Cake Troubleshooting Guide
Most cake problems come down to oven accuracy, leavening, mixing, and pan size, not a bad recipe. Frosting problems have their own guide.
Some links on this page are Amazon affiliate links — as an Amazon Associate we earn from qualifying purchases, at no extra cost to you.
Greasing the sides of a sponge or chiffon cake pan
Light, foam-leavened batters (sponge, chiffon, angel food) climb the pan wall as they rise. A greased side is slippery, so the batter can't grip it, and the cake may rise less or unevenly. Rich butter cakes are different: most recipes still grease and line those pans.
For sponge and chiffon cakes, grease and line only the bottom with parchment and leave the sides bare, then run a thin knife around the edge after baking to release it. Follow your recipe for butter cakes.
Overmixing cake batter once the flour goes in
Mixing flour with liquid develops gluten, the stretchy protein network. A little gives structure, but too much makes the cake dense, tight-crumbed, and rubbery instead of light and tender.
Add the dry ingredients in two or three parts on low speed or by hand, and stop as soon as no dry flour is visible. A few small lumps are fine and smooth out while baking.
Baking a cake until the top cracks or the edges dry out
A cracked, domed top usually means the oven is too hot, so the outside sets before the middle finishes rising and then splits. An overfilled or too-small pan does the same. Dry cake is usually overbaking, or too little fat or liquid in the batter.
Bake at the recipe temperature (check it with an oven thermometer), use the right pan size, fill pans no more than about two-thirds, and start testing a few minutes before the minimum time.
Cake sinks in the middle
Usually underbaking, opening the oven door before the cake has set, or too much leavening. The structure collapses because it has not firmed up enough to hold the bubbles.
Bake until a toothpick comes out clean, keep the oven door closed until near the end, and measure baking powder and soda exactly.
Cake is flat or does not rise
Expired or too little baking powder or soda, overmixing, too much liquid or flour, an oven that is not preheated, or a pan that is too large for the batter.
Check expiry dates, mix just until combined, measure flour by weight, preheat for 10-15 minutes, and use the pan size the recipe calls for.
Cake sticks to the pan
The pan was not greased or lined enough. Cakes can tear apart at the unmolding step even when the bake is perfect.
Grease and line the bottom with parchment, run a thin knife around the edge, and let the cake cool in the pan for about 10 minutes before turning it out.